Steering lock issue with my tx leather edition (t300)

[[RDSR] Raphi]

Hi

I recently noticed that my steering wheel, a Thrustmaster tx leather edition, locks pretty early on the right:
-on the left it goes 1 turn 1/4, like it should
-on the right the ffb motor kicks in to block the steering at 1 turn 1/8 (roughly). With some more force I can turn the wheel past the "soft" lock and turn it to 1 and 1/4 until it blocks again.
In games it is detected like the steering lock was at 1 turn 1/8; if I turn the wheel past it, it acts like a deadzone.

Does anyone had this kind of issues? I've tried many softwares including firmware updates etc.

Apart from that the wheel calibrates nicely, left to right and then it centers perfectly.

[SO•Mercury]

As others have noticed in this reddit thread, you shouldnt worry, instead i would advise you to lower the maximum DoR to 870 or 860 and then rechech the TM software if the bumpstop hits 100% there.

[[RDSR] Raphi]

Oh well I haven't see this thread even with my hours of researching on the internet for a solution.
Thanks, I sometimes set the rotation to 540 or 720 anyway but when I cruise I like to have it at full 900.
Anyway I'll test it later, thanks